Date:11/20/2008
Vehicle: 1998 Honda Accord
Transmission: Honda BAXA
Subject: Honda BAXA, Bind on 2-1 downshift with light throttle MCJA
Complaint: Bind on 2-1 downshift driving up hills
Reply to this problem
Read all the responses

Date:11/20/2008
Vehicle: 2002 Dodge Intrepid
Transmission: A606
Subject: A606, Codes 1776 and 0750 alternate, and in limp mode.
Complaint: No past repairs done. Vehicle is a no go now.
Reply to this problem
Read all the responses

Date:11/20/2008
Vehicle: 2002 Mazda MPV
Transmission: JF506E
Subject: JF506E, BURN REVERSE AND HIGH CLUTCH
Complaint: SAME,CAR GOES NEUTRAL AFTER A WHILE, BURN REVERSE AND HIGH CLUTCH.
Reply to this problem
Read all the responses

Date:11/19/2008
Vehicle: 2000 Ford F-150, 4.6L
Transmission: 4R70W
Subject: 4R70W, Harsh Reverse after rebuild
Complaint: Harsh reverse after rebuild
Read the Fix

Date:11/18/2008
Vehicle: 2004 Ford free star, 3.9
Transmission: AX4N
Subject: 4F50N, code po741
Complaint: code po741 tcc stuck off
Read the Fix

Date:11/17/2008
Vehicle: 2002 Land Rover Rangerover HSE, 4.6
Transmission: ZF4HP24
Subject: ZF4HP24, Need internal wiring diagram with pin locations
Complaint: tcc and shift sol a wires came loose from trans connector inside of trans
Read the Fix

Date:11/20/2008
Vehicle: 2000 Toyota Tacoma 4X4
Transmission: A340E
Subject: A340E, Trans Waisted Need a core
Update: This vehicle was rebuilt in Oklahoma in 2003. The customer says he always had a problem going into lock up. We fixed the lockup issue but the harsh shift on medium to heavy throttle still continues 1-2, 3-4. Dealer says this vehicle does not require reprogramming. The L/U sol code comes back after approx 50 miles of driving. The solenoid is a dealer issue, the T/C was cut open again and found in good condition, the TPS was changed. Any help I can get from the pros out there I will be eternally grateful for. I do yards, and can landscape!!!!! Thanks guys.
Reply to this problem
Read all the responses

Date:11/17/2008
Vehicle: 2003 Ford Taurus
Transmission: AX4N
Subject: AX4N, Hydraulic Diagrams
Update: well I installed new converter today. I still have p0741 tcc stuck off. I ran the van on the rack and watched tcc % and it stayed steady at 100 %. I beleive My sprocket count is right. This one is kicking my <<>>>. Any help out there on this code. I'm going to pull it out; and put back on the table. Recheck everythang again. Murrell
Reply to this problem
Read all the responses

Date:11/12/2008
Vehicle: 2003 Ford Taurus
Transmission: AX4N
Subject: AX4N, Hydraulic Diagrams
Update: I have replaced valve body. I also sent to ford for a reflash. still no change. well ALSO WHEN YOU DRIVE ON THE HIGHWAY AT 70 MPH YOU CAN SEE THE TCC % GO UP TO 100 % STAY FOR JUST A SECOND THEN DROP TO 0% . THEN IT GOES BACK UP TO 100% THEN DROPS BACK TO 0%. THEN HERE COMES PO741 TCC STUCK OFF.I'M GOING TO PUT A NEW CONVERTER IN IT TOMMORROW. ANY HELP WOULD BE VERY APPRECIATE. Murrell
Reply to this problem
Read all the responses